SPECIFICATIONS

• 3,000 - 5800 PSI
  
• ASME “U” Stamp, Section VIII, Div 1 Pressure Vessel
  
• Each Vessel National Board Registered
  
• Type L - Skid Vertical Sand Trap
  
• Design - 5,800 PSI MAWP @ 100 Degrees F Pressure - 7,800 PSI Hydrostatic Test
  
• Inlet - 3” 1502 Female (Thread End) Hammer Union Located on Vessel Side, Below Upper Head
  
• Sand out - 2 - 2” 1502 Male (Wing End) Hammer Unions. Located 180 Degrees Apart on Vessel Side Above Bottom Head
  
• Clean-out - 2” 1502 Male (Wing End) Hammer Union Located on Bottom Center of Bottom Head
  
• Gas Out - 3” 1502 Male (Wing End) Hammer Union. Located on Top Center of Top Head